Print
  1. Click “Start” menu and type “services.msc” and press ENTER.
    win7wired_v2_p1e
  2. Right Click on “Wired AutoConfig” and select “Properties”.
    win7wired_v2_p2e
  3. Click the “General” tab and select the following settings:
    1. Set “Startup type” to Automatic”.
    2. Click “Start” to start the service.
    3. Click “Apply”.
    4. Click “OK”.

    win7wired_v2_p3e

  4. Click “Start” menu again and click “Control Panel.
    win7wired_v2_p4e
  5. Click the “Network and Sharing Center”.
    win7wired_v2_p5e
  6. Click “Change adapter settings” on the left hand side of the screen.
    win7wired_v2_p6e
  7. Right click the “Local Area Connection” and select “Properties” for further configuration.
    win7wired_v2_p7e
  8. Click the “Networking” tab and select the following settings:
    1. Double Click “Internet Protocol version 4 (TCP/IPv4)”.
    2. Select “Obtain an IP address automatically” and “Obtain DNS server address automatically”.
    3. Click “OK“.

    win7wired_v2_p8e

  9. Click the “Authentication” tab and select the following settings:
    1. Check “Enable IEEE 802.1X authentication”.
    2. Choose “Microsoft: Protected EAP (PEAP)”.
    3. Uncheck “Fallback to unauthorized network access”.

    win7wired_v2_p9e

  10. Click “Settings” button. Uncheck all the settings as shown in the picture.
    win7wired_v2_p10e
  11. Choose “Secured Password (EAP-MSCHAP v2)” in “Select Authentication Method”, and then click “Configure…”. Uncheck it and then click “OK”.
    win7wired_v2_p11e
  12. Click the “Authentication” tab and select the following settings:
    1. Click “Additional Settings…”.
    2. Check “Specify authentication mode” and choose “User authentication”.
    3. Uncheck “Enable single sign on for this network”.

    win7wired_v2_p12e

  13. Click “Save credentials” button and input your UMPASS user ID and password. After finish, click “OK”.

    The password is case sensitive and the user name is in lowercase.
    If you are student, username contains only the first seven digits of your student ID without the hyphen and last digit. e.g. “ab12345”.

    win7wired_v2_p13e

  14. Click “OK” to save your changes.
    win7wired_v2_p14e